hi,
I created a schematic. Did the layout (NOT routing yet). Then I change
the schematic, e.g., removing and adding components and connections,
etc. My *.brd file is NOT 100% updated even repeated save on the
schematic file.
Please advise. Thanks
hi,
I created a schematic. Did the layout (NOT routing yet). Then I change
the schematic, e.g., removing and adding components and connections,
etc. My *.brd file is NOT 100% updated even repeated save on the
schematic file.
Please advise. Thanks
On 6/6/2010 12:38 PM, Christen Fihl wrote:
brd and sch has to be open both at all time.
Can this be a problem?
I had made sure that the *.sch and the *.brd files are always both open
at the same time. (I had learned this lesson a long time ago 
This
is what confuses me.
ratnest, saving and other playing around does no problem, as long as both
are open always.
This problem can be hard to fix.
If board layout are not that big yet, then I would get rid of the board,
open the sch alone, and then start over again by making a new brd.
Yeah, looks like I have to.
Christen
On 06/06/2010 06:29 PM, AL wrote:
On 6/6/2010 12:38 PM, Christen Fihl wrote:
brd and sch has to be open both at all time.
Can this be a problem?
I had made sure that the *.sch and the *.brd files are always both open
at the same time. (I had learned this lesson a long time ago
This is
what confuses me.
Could you have had two instances of Eagle open? One with the sch and one
with the board.
Paul
On 6/6/2010 5:17 PM, Paul Romanyszyn wrote:
On 06/06/2010 06:29 PM, AL wrote:
On 6/6/2010 12:38 PM, Christen Fihl wrote:
brd and sch has to be open both at all time.
Can this be a problem?
I had made sure that the *.sch and the *.brd files are always both open
at the same time. (I had learned this lesson a long time ago
This is
what confuses me.
Could you have had two instances of Eagle open? One with the sch and one
with the board.
Nope...just one instance. I guess I have to re-do the *.brd file.
Paul
