Consistency errors

On 8/31/2016 12:00 PM, Jim McAuley wrote:

Well, its happened again. I have consistency errors. How do I resolve them. I have tried to delete the offending part from the schematic, both with the board open and closed. I have tried replacing the offending part with a new part from a brand new library. I have tried to delete the part from the schematic, close the schematic reopen the schematic and the board. I have airwires on the board but can't place or select the part. What do I try next?

 

--

To view any images and attachments in this post, visit:

https://www.element14.com/community/message/204818

 

Hi Jim,

I hope you're doing well. Remember to always have the board and

schematic open at the same time together. That will avoid running into

consistency issues.

Remember to run the ERC often as you make changes to make sure you are

going the right direction. When you are trying to get back consistency

you need both the schematic and the board to be open at the same time.

How many errors do you have now? If the error is part is found in one

editor but not the other. Then the easiest thing to do is to remove the

part from the editor that has it.

Remember that ALL of the consistency errors must be resolved before you

can regain consistency and continue working.

hth,

Jorge Garcia

On 8/31/2016 12:00 PM, Jim McAuley wrote:

Well, its happened again. I have consistency errors. How do I resolve them. I have tried to delete the offending part from the schematic, both with the board open and closed. I have tried replacing the offending part with a new part from a brand new library. I have tried to delete the part from the schematic, close the schematic reopen the schematic and the board. I have airwires on the board but can't place or select the part. What do I try next?

 

--

To view any images and attachments in this post, visit:

https://www.element14.com/community/message/204818

 

Hi Jim,

I hope you're doing well. Remember to always have the board and

schematic open at the same time together. That will avoid running into

consistency issues.

Remember to run the ERC often as you make changes to make sure you are

going the right direction. When you are trying to get back consistency

you need both the schematic and the board to be open at the same time.

How many errors do you have now? If the error is part is found in one

editor but not the other. Then the easiest thing to do is to remove the

part from the editor that has it.

Remember that ALL of the consistency errors must be resolved before you

can regain consistency and continue working.

hth,

Jorge Garcia

I currently have 3 errors and two warnings, all on the schematic.

The errors are "Different connections on Pins" on two different parts.

The warnings are "Only one pin on net" for two different nets.

What do I do to correct these errors, and will this get me back consistency?