external wiring for LTC3588 chip

jim1995 over 7 years ago

Hi, im pretty new to the eagle software and am in need to make a PCB for my LTC3588 chip. As the LTCC3588 chip is rather small (3mm x 3mm), i would like to place it on a PCB and connect external wires for use. how am i to place external wire to the PCB using the eagle software? would appreciate your help very much.

Parents

0 genebren over 7 years ago

Patrick,

There are a lot of pin headers (pinhead.lbr) that can be used as wiring points. Most of these are either single or dual rows with 0.1" spacing between pads. You can directly solder wires to these points fairly easily or you can add header pins (like those used on a lot of development boards) and use jumper wires.

Good luck.
Gene
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 genebren over 7 years ago

Patrick,

There are a lot of pin headers (pinhead.lbr) that can be used as wiring points. Most of these are either single or dual rows with 0.1" spacing between pads. You can directly solder wires to these points fairly easily or you can add header pins (like those used on a lot of development boards) and use jumper wires.

Good luck.
Gene
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data