This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Drag selection of objects

Hello,

In Altium I was able to use inclusive or anything touching drag selection and in CircuitMaker I can't do anything similar, I can either select them all around but not partial which touches wires or etc take a look in screen grabs to understand my problem... I am trying to figure out app before buying but there are some issues like these...

Altium:

https://gyazo.com/5e0b5a6db59aaf58cb73e420b4061a2e

CircuitStudio:

https://gyazo.com/5e0b5a6db59aaf58cb73e420b4061a2e

Maybe I am just doing something wrong.

Kind Regards,

Aurimas

0 e14softwareuk over 6 years ago

I think you may have linked the same screenshot twice so we're missing Altium Designer.
Cancel
Vote Up 0 Vote Down

Cancel
0 gcds over 6 years ago in reply to e14softwareuk

Oh sorry, I am not on the same computer, but I found this feature in altium docs it's called "Smart Drag Select"

https://www.altium.com/documentation/17.0/display/ADES/NFS_17_0((Selection+&+Display+Improvements))_AD#!SelectionDisplayImprovements-SmartDragSelect
Cancel
Vote Up 0 Vote Down

Cancel
0 e14softwareuk over 6 years ago

CircuitStudio does not feature this type of smart select but you might want to try the Select > Touching Line and Select > Touching Rectangle commands as these should meet your requirements.
CircuitStudio Hidden Commands
Cancel
Vote Up 0 Vote Down

Cancel