Actions
Forum Thread Details
  • Locked Locked
  • Replies 7 replies
  • Subscribers 87 subscribers
  • Views 1043 views
  • Users 0 members are here
Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Issues with Tending top and bottom

saravananeceait

Here I have attached an image please give me  the right solution for this !

Attachments:
image
image
Parents

  • Hi. Not sure if the diagram is showing pads or vias, however you can achieve a solder mask clearance rather than tented quite easily. Bring up the properties dialog for the via/pad and make sure Force Tenting Top/Bottom options are not checked. Next if you have specified a Solder Mask Expansion Value this may need adjusting, the larger the number the more clearance around the hole. Finally if the previous have not fixed it then check the design rules where a Solder Mask Expansion rule may need adjusting.

    image

Reply

  • Hi. Not sure if the diagram is showing pads or vias, however you can achieve a solder mask clearance rather than tented quite easily. Bring up the properties dialog for the via/pad and make sure Force Tenting Top/Bottom options are not checked. Next if you have specified a Solder Mask Expansion Value this may need adjusting, the larger the number the more clearance around the hole. Finally if the previous have not fixed it then check the design rules where a Solder Mask Expansion rule may need adjusting.

    image

Children
No Data