This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Gerber files are mixed up!!!

mah1990 over 7 years ago

Hallo,

I do have a problem with my circuit studio. The Gerber files which are generated are mixed up. I for example i will get some Components names on my Outline file instead of the out shape of me board !!!!

I have checked my design and all layers are good in the CSPcbDoc.

Parents

e14softwareuk over 7 years ago

Hi
If you are convinced everything is correct when viewing the PCB could you post a screenshot of your Gerber Setup : Layers dialog so that we can check the layer generation?
Cancel
Vote Up 0 Vote Down

Cancel
mah1990 over 7 years ago in reply to e14softwareuk

Hier you can find the pics https://drive.google.com/open?id=1kxwCJHYFy-ZMi86Gj0CXczVZaX7cXRxh
Cancel
Vote Up 0 Vote Down

Cancel
e14softwareuk over 7 years ago in reply to mah1990

Please could you post the images directly into the forum - not everyone has access to google drive due to IT policies.
Cancel
Vote Up 0 Vote Down

Cancel
mah1990 over 7 years ago in reply to e14softwareuk

I did try to do that, but the chat will not accept GIF, JPG, MHT or PNG files!!
Cancel
Vote Up 0 Vote Down

Cancel
e14softwareuk over 7 years ago in reply to mah1990

If you are replying to a post you should be able to just drag or copy & paste an image into the reply.
Cancel
Vote Up 0 Vote Down

Cancel
mah1990 over 7 years ago in reply to e14softwareuk
Cancel
Vote Up 0 Vote Down

Cancel
e14softwareuk over 7 years ago in reply to mah1990

Thanks for the images, this all looks good. Two suggestions (1) try removing/renaming the *.OutJob file in the project folder and set-up and create the Gerbers again, if that doesn't solve the problem (2) can you email me directly the PCB file so that I can take a look.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

e14softwareuk over 7 years ago in reply to mah1990

Thanks for the images, this all looks good. Two suggestions (1) try removing/renaming the *.OutJob file in the project folder and set-up and create the Gerbers again, if that doesn't solve the problem (2) can you email me directly the PCB file so that I can take a look.
Cancel
Vote Up 0 Vote Down

Cancel

Children

e14softwareuk over 7 years ago in reply to e14softwareuk

Thanks for sending through the PCB document, I've replied directly to you.
Cancel
Vote Up 0 Vote Down

Cancel
mah1990 over 7 years ago in reply to e14softwareuk

Thanks,
you did solve the Problem.
Cancel
Vote Up 0 Vote Down

Cancel
mars01 over 7 years ago in reply to e14softwareuk

Can you post the solution here ?
That's the idea of the forum, if others will have this problem, they can read about it here.
Cancel
Vote Up 0 Vote Down

Cancel
e14softwareuk over 7 years ago in reply to mars01

Hi Marius, the solution was some extraneous text in the library components. To see you need to turn on the layers in the library editor.
Cancel
Vote Up 0 Vote Down

Cancel