Cirrus 'No such device' after reboot

I have a RPi2 and a Cirrus Logic Audio Card. For the installation I used Method A: Complete image install from the Cirrus Logic Audio Card User Documentation. When finished the card was recognized and I could control audio playback and record by using the scripts.

After rebooting the RPi the card is no longer recognized: aplay -l doesn't show it and when using a script I get: amixer: Control hw:sndrpiwsp open error: No such device

The config.txt is showing dtoverlay=rpi-cirrus-wm5102-overlay and there is a rpi-cirrus-wm5102-overlay.dtb in the overlays folder.

I'm a RPi user beginner and need an advice how to figure this out.

Thanks a lot,

Martin

Parents

spambake over 10 years ago

It's impossible to tell what the problem is without a lot more information and troubleshooting. BUT, one of the more common causes of this is if you ran:
apt-get update apt-get upgrade
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
e14 Contributor over 10 years ago in reply to spambake

hello spambake, thanks a lot for your answer.
You are right: I should have explicitely mention that I did a clean install of the downloaded cirrus_logic_audio_card_all_pi_versions.img and after the next reboot I got the error.
And you are also right: I did the apt-get update and upgrade thing just after installing the image. So this was the mistake I did.
So now after a new installation of the image and without the update/upgrade the cirrus card is still recognized after reboot.
Thanks very much.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
e14 Contributor over 10 years ago in reply to e14 Contributor

I also tried the method explained in the thread
Driver fixes and updates to kernel 3.18.16 and 4.0.5
with a new installed Raspbian Jessie using the http://www.horus.com/~hias/tmp/cirrus/cirrus-linux-4.1.6.tgz and doing the modifications in config.txt and raspi-blacklist.conf like discribed in the thread and it is also working fine.
Thank you all for your great work here.
Martin
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

e14 Contributor over 10 years ago in reply to e14 Contributor

I also tried the method explained in the thread
Driver fixes and updates to kernel 3.18.16 and 4.0.5
with a new installed Raspbian Jessie using the http://www.horus.com/~hias/tmp/cirrus/cirrus-linux-4.1.6.tgz and doing the modifications in config.txt and raspi-blacklist.conf like discribed in the thread and it is also working fine.
Thank you all for your great work here.
Martin
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data

Cirrus 'No such device' after reboot

Driver fixes and updates to kernel 3.18.16 and 4.0.5

Driver fixes and updates to kernel 3.18.16 and 4.0.5