What is the "HUB" pinout for the Bitscope Blade Uno?
And while we are at it, the documentation seems to imply that there is a processor reset facility on the board. Is there one, and if so where is it?
What is the "HUB" pinout for the Bitscope Blade Uno?
And while we are at it, the documentation seems to imply that there is a processor reset facility on the board. Is there one, and if so where is it?
Hi Mike, the hub connector is standard across the range, as per attached. The 4 pin connector allows you to pull the power and send signals on pin GP21. There's currently no software associated with this but you could use something like ipv1 'a software solution Adding a Shutdown Button to the Raspberry Pi B+ swapping the pin to 21.
Hi Mike, the hub connector is standard across the range, as per attached. The 4 pin connector allows you to pull the power and send signals on pin GP21. There's currently no software associated with this but you could use something like ipv1 'a software solution Adding a Shutdown Button to the Raspberry Pi B+ swapping the pin to 21.
