pi won't boot with gertduino

I have installed arduino ide on denbian pi and followed the drogon.net instructions but I still get a sh can't access tty on power up and the whole thing stops there.

any ideas ?

Parents

0 johnbeetem over 12 years ago

One possibility is that your power supply and/or micro USB cable can't handle the additional load you get with Gertduino attached. I don't know how much current Gertduino uses. Here's the RasPi Troubleshooting Wiki scrolled to the part about debugging power problems.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 12 years ago in reply to johnbeetem

the actual error is
sh : can't access tty : job control turned off
/ #
its unlikely to be a power issue , the same setup runs fine with a chipkit_pi on board.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 12 years ago in reply to Former Member

fixed
Atmega48 reset pin (re) and she boots. I uploaded blink to the gertduino successfully and the rpi will now boot without the atAtmega48 reset
see
Raspberry Pi • View topic - raspberry pi doesn't boot [solved (sort off)]
Cancel
Vote Up 0 Vote Down

Sign in to reply

Reject Answer

Cancel
0 Former Member over 12 years ago in reply to Former Member

Excellent find Richard glad you got it sorted!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Former Member over 12 years ago in reply to Former Member

Excellent find Richard glad you got it sorted!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data