Cirrus Logic Audio Card Enclosure for Pi Model B+ / Pi 2 Model B

Question

Hello, I was recently making a research about an enclosure option for the Raspberry Pi Model B+ with the Cirrus Logic audio card but I couldn't really find anything. I was wondering if any of you could have seen something that might work? I own the Pi model B with the Wolfson card and have them equipped with this enclosure ( http://uk.farnell.com/camdenboss/wolfson-board-case-carbon/enclosure-box-abs-carbon-fibre/dp/2407263 ), but apparently the form factor is different and I can't suit it to fit he Model B+ with the Cirrus Logic audio card.

e14 Contributor · Answer

Here is one picture. Misteeq .

marcelheijkoop · Answer

Hi Enrico, Since the cards are back in use with me , I too am shopping for a case. Recently I discovered ready design for laser cut in thingiverse : https://www.thingiverse.com/thing:785289 And I assume these designs can somehow be used for input in your design. In stead of cutting the 6 sides you could pint them as almost 2d objects for x mm thick. and now I look again, I also see a 3d print design: https://www.thingiverse.com/thing:1928071 It is a 3 object set that needs 4 screws and nuts to keep it together. With some modifications you could eliminate the use of the original pillars and nylon screws , as the middle object is embraced by the pi and and clac PCB. And should be able to supports the boards like the pillars would do With the top and bottom lid added to that , correct sized rubber bands could hold it together . If you decide to print some, let me know how I can get them too. Regards M PS: And let's add a few peak holes to see the leds for the clac and pi 2B and 3B ! ps2: I see the 3D print design has internal struts for the PCB separation but only at the GPIO side , and would be more useful at the other side. Else the outside shell is the only one clamping the 3.5 mm connectors on their barrels.