RoadTests & Reviews

RoadTest Forum Help me to setup the software to use the trimak motor

Join RoadTests & Reviews to participate - click to join for free!

Actions

Forum Thread Details

Replies 91 replies
Subscribers 2743 subscribers
Views 4331 views
Users 0 members are here

Related

Help me to setup the software to use the trimak motor

manojroy123 10 months ago

I am trying to install TMCL-IDE for windows. I am getting this error. Please help me in solving it.

Parents

manojroy123 10 months ago

After asking on chatgpt it says that you need to configure the motor from Wizard Pool in TMCL-IDE 4.x. But Wizard Pool is not showing any motor. Bellow is the pic of it.

How to know what has caused the error of device not detection on Wizard Pool of the TMCL-IDE 4.x
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
beacon_dave 10 months ago in reply to manojroy123

May be relevant ?

"I found that most of my plugins were disabled.
Once I enabled them again, I was able to use the wizard."

https://ez.analog.com/motor-control-hardware-platforms2/f/q-a/599152/with-evaluation-board-tmc9660-3ph-evalv1-1-boot-setting-is-good-but-wizard-is-empty
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
manojroy123 10 months ago in reply to beacon_dave

I have updated firmware with latest version. Still showing same problem. How to enable plugins.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
beacon_dave 10 months ago in reply to manojroy123

It looks like it turns red once the motor supply voltage reaches an acceptable threshold but it's the type of behaviour that would be best verified by referring to the user documentation for the TMCL-IDE.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
manojroy123 10 months ago in reply to beacon_dave

yes
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

manojroy123 10 months ago in reply to beacon_dave

yes
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

beacon_dave 10 months ago in reply to manojroy123

It looks like it turns red once the motor supply voltage reaches an acceptable threshold but it's the type of behaviour that would be best verified by referring to the user documentation for the TMCL-IDE.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel