Opinions on the MakiBox

want to get into 3D printing on a budget and curious if there is anything other then the MakiBox that would be good for a beginner or if the MakiBox is ideal for a beginner

Top Replies

Former Member over 11 years ago in reply to Former Member +1

Joseph, Are you going to contribute anything other than sales pitches to the Element14 Forums?

Parents

Former Member over 11 years ago

I've been looking into this also, and the one i am leaning toward is the One-Up (199.00) or Two-Up (279.00) from this website
http://store.quintessentialuniversalbuildingdevice.com/

Saving up the money right now, but there is a pretty good Youtube channel on the Two-Up called "3dPrintedLife".

Only prints PLA, but upgradeable to ABS with a 79.00 heat bed.

They Also sell a 79.00 upgrade to the One-Up that increases your build area to the two-up size.

(I think its mostly US made). Company is based in US which is a plus.
Shipping is seperate.
Hope this helps.
-Dan
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Former Member over 11 years ago

I've been looking into this also, and the one i am leaning toward is the One-Up (199.00) or Two-Up (279.00) from this website
http://store.quintessentialuniversalbuildingdevice.com/

Saving up the money right now, but there is a pretty good Youtube channel on the Two-Up called "3dPrintedLife".

Only prints PLA, but upgradeable to ABS with a 79.00 heat bed.

They Also sell a 79.00 upgrade to the One-Up that increases your build area to the two-up size.

(I think its mostly US made). Company is based in US which is a plus.
Shipping is seperate.
Hope this helps.
-Dan
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data