started getting the bends

its late at night just finished work and cant figure out why my prints are doing this anyone have any suggestions I know I should know whats up it did print fine before, like it wants to fly away on me.

Top Replies

gam3t3ch over 8 years ago +3

Just a update I have slowed the speed down a bit more and and increased the flow slightly and now have silky smooth ABS prints again on a 60oC bed. Save
Robert Peter Oakes over 8 years ago +1

Looks like a classic ABS adhesion issue, 1. Clean the bed with Alc 2. check bed temperature is getting to what is needed 3. have you changed your hairspray recently , or perhaps simply a new bottle that…

Parents

michaelwylie over 8 years ago

Is this a heated bed? Have you cleaned it with alcohol recently?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
gam3t3ch over 8 years ago in reply to michaelwylie

Yes it's a heated bed only 12v so only get 80oC on it. Rechecked my bed for being level that's all good checked my printer settings nothing changed there. Using hair spray on the bed and yes recently cleaned the bed. Looks a bit high tho on the start of the print I noticed on a new print this morning. Possibly my first layer hight? Idk need a coffee in me here before I start thinking too much lol
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
michaelwylie over 8 years ago in reply to gam3t3ch

ABS?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

michaelwylie over 8 years ago in reply to gam3t3ch

ABS?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data