I am using this FX292X-100A-0100-L compact compressive load cell; however, I am not sure how to wire the analog mv/V version of it. I am not quite sure where the O- and O+ wires go on the datasheet. For context, I am trying to wire to a Teensy 4.1 microcontroller.
I have a follow up question. My goal is to read ground reaction forces by putting these on a foot plate. I'm not sure how to get the sensor to contact the ground in a protrusion. I was thinking of applying a very strong adhesive to the sensor and attach a protruding T plate to measure ground reaction forces. I'm not sure if this is a feasible solution sense the contact zone for the area is so small; it could possibly easily fall apart regardless of the strength of the adhesive. Are there any other recommendations for how to do this?
