Hello every body
I have one problem with my solder station Multicomp MP740068, some time I have a message E-6 Voltage EXCP and it stops to warm, if I wait 10 minutes it reworks correctly but some time not at all, what's appened?
sincerely, ch
Be sure to click 'more' and select 'suggest as answer'!
If you're the thread creator, be sure to click 'more' then 'Verify as Answer'!
Hello every body
I have one problem with my solder station Multicomp MP740068, some time I have a message E-6 Voltage EXCP and it stops to warm, if I wait 10 minutes it reworks correctly but some time not at all, what's appened?
sincerely, ch
That soldering station appears to be a rebadged Atten GT-5150. The manual is available here - https://www.es.co.th/Documents/GT-5150.PDF
According to the manual, E-6 is the following:
It may be related to poor power quality - check your mains power is stable and clean. Otherwise, it could be a bad cord, power-point, or switch contact. Make sure all cords are firmly plugged in and that any fuses are also properly installed. If there is a manual voltage selector, make sure it's correctly set to the line voltage in your area (or check that the unit you have is correct for your area, especially if you imported this unit from overseas).
Otherwise, it's more likely than not a fault in the base unit and you'll have to send it back for repair or replacement.
- Gough
Thank you all,
I checked with the thermal camera, nothing to report, and after several tests I concluded a problem with the R37 multi-turn adjustable, the first time I touched it and the iron worked normally again immediately and the second time I turned the adjustable and I am no longer broken.
