H
I want to run a projector from my 12V circuit.
The projector is 14V and 3.5 Amp -
I don't really want to use an inverter.
Is there a simple way to step up 12V to 14V ?
thanks v. much
H
I want to run a projector from my 12V circuit.
The projector is 14V and 3.5 Amp -
I don't really want to use an inverter.
Is there a simple way to step up 12V to 14V ?
thanks v. much
If you just want an off-the-shelf solution you may want to try to get a DC-to-DC converter from a company like Vicor. Look at: http://cdn.vicorpower.com/documents/datasheets/ds_vi-j00.pdf
which offers up to 100W supplies in a half brick. However, many times these companies offer many different outputs and inputs, but do not stock non-standard one, but it may be worth a try.
If you want to build your own as one replier suggested, ti.com or linear.com both have chips, circuits and on-line software to design supplies. Try National's (recently bought by Texas Instruments) WEBENCH at http://www.national.com/ and input the data into Webench Designer. With your input and output requirements they have about 7 or 8 different solutions including the LM3481MM/NOPBLM3481MM/NOPB from another replier.
Lee
Why don't they make these nice new parts as through hole or better yet monsterous so an old hog like me can bolt them to a 2x4 and solder house wiring to the pins?
Why don't they make these nice new parts as through hole or better yet monsterous so an old hog like me can bolt them to a 2x4 and solder house wiring to the pins?