i wanna make gps quided car with Arduino Uno R3. which gps shield, module and antenna may i buy?
i wanna make gps quided car with Arduino Uno R3. which gps shield, module and antenna may i buy?
I've heard good things about Adafruit's Ultimate GPS breakout board: http://adafruit.com/products/746
They have nice tutorial for it, too: http://learn.adafruit.com/adafruit-ultimate-gps
is that shield suitable for Arduino?? 26.40$ + free shipping
http://dx.com/cn-06-gps-receiver-super-u-blox-gps-module-w-active-ceramic-antenna-mwc-149340?item=1
dealextreme is my nu 1 :) so cheap and free shipping :) i strongly reccomend.
I will also ask you about quadrocopter parts but not that time becouse im not at that level:)
http://www.AeroQuadStore.com/Logic_Level_Converter_p/bob-08745.htm
Can i use "logic level converter" to convert 5.0V of arduino to gps's 3.6V
Or
Is arduino's 3,7V pin enough?
You can power it from the Arduino 3.3V power connection.
Remember do not connect the Arduino Tx to the GPS Rx - that will quite likely kill it.
Only connect the Arduino Rx to the GPS Tx,
GND to GND
and Arduiono 3.3V to GPS VCC.
Thank you again:) i bought it. It will be my hand 15 daysy later than i will post my experiences with you:)
There is also this one, very interesting:
helpful page thanks
Today i get my gps module.i tried, it works with simon.monk's code. thank you simon.monk.
i used arduino uno r3 and followed doctor monk's recommendations and codes and i did.
http://www.doctormonk.com/2012/05/sparkfun-venus-gps-and-arduino.html
26.4 $ gps module works with arduino. i recommend it
it works nice
help me please .
i try your sample code above to connect gps receiver ublox cn06 v3 with arduino uno , but i got nothing on serial monitor .
i'm confused.
help me please .
i try your sample code above to connect gps receiver ublox cn06 v3 with arduino uno , but i got nothing on serial monitor .
i'm confused.