Freedom development platform

Welcome to

KL25Z Freedom Board is our low-cost evaluation and development board featuring theCortex-M0+ based Kinetis L Series MCU exclusively available to pre order today.

Recent Discussions

Discussion

Prototype shield for the Freedom Board?

2664 views

11 replies

Latest over 2 years ago
by yangkuki
Not Answered

Baremetal Code needed for KL25Z UART 0

624 views

0 replies

Started over 5 years ago
by mcuism
Suggested Answer

Bricked FRDM-K82F 0

1462 views

5 replies

Latest over 7 years ago
by cybermah
Not Answered

NXP FRDM-HB2001-EVM, MC33HB2001 Configure to Half Bridge Mode 0

451 views

0 replies

Started over 7 years ago
by hweiko
Not Answered

NOR , NAND Flash tests at u-boot level 0

526 views

0 replies

Started over 8 years ago
by sathi

Recent Blogs

Kinetis Design Studio 3.0 + Kinetis SDK 1.2 Processor-Expert using FRDM-KL27Z: Blink Red Led with TPM (Timer/PWM Module)

bheemarao

Here is a Project created using new KDS version 3.0 and Kinetis software development kit 1.2 on processor expert platform. This is a project for blinking an RED LED using TPM module of PE implemented using freedom board FRDM-KL27Z.RequirementsTo run …
- 13 Jul 2015
Brave New Hello World

elecia

At O’Reilly’s Solid conference, I presented an introduction to using inertial sensors. In the talk, I passed around a hardware demonstration to illuminate accelerometers, angular rate sensors, and magnetometers. The device is "hello world&q...
- 30 Jun 2015
[FRDM-K64F +KDS3.0 + Processor Expert(PE)] Tutorial: working with Xtrinsic Sensor Board with switch interface and displaying data on hyper terminal

bheemarao

Brief Introduction:This project introduces on interfacing e14 xtrinsic sensor board to Kinetis freedom board K64F. As we know xtrinsic sensor board is having pin compatible of arduino interface and K64F is also having arduino compatible interface so …
- 23 Jun 2015