Freedom development platform

Welcome to

KL25Z Freedom Board is our low-cost evaluation and development board featuring theCortex-M0+ based Kinetis L Series MCU exclusively available to pre order today.

Recent Discussions

Discussion

Prototype shield for the Freedom Board?

2662 views

11 replies

Latest over 2 years ago
by yangkuki
Not Answered

Baremetal Code needed for KL25Z UART 0

622 views

0 replies

Started over 5 years ago
by mcuism
Suggested Answer

Bricked FRDM-K82F 0

1459 views

5 replies

Latest over 7 years ago
by cybermah
Not Answered

NXP FRDM-HB2001-EVM, MC33HB2001 Configure to Half Bridge Mode 0

451 views

0 replies

Started over 7 years ago
by hweiko
Not Answered

NOR , NAND Flash tests at u-boot level 0

526 views

0 replies

Started over 8 years ago
by sathi

Recent Blogs

How to set and check the 48-bit BLE MAC Address into KW4xZ/3xZ

bheemarao

The content has been cited from https://community.nxp.com/thread/429919 Below is the summary on how to write and read MAC address for KW40/41 MCUs cited from NXP community https://community.nxp.com/thread/429919 On the BLE Host Stack...
- 22 Aug 2016
Executing Wireless messenger Application using KW40Z connectivity software [Demonstrating and executing the cloning of wireless messenger project using FRDM-KW40Z NXP Freedom Development Platform]

bheemarao

This document shows a brief demonstration on executing wireless messenger application using NXP Bluetooth FRDM-KW40Z wireless development board. To proceed further the below are the prerequisites:1. The freedom hardware board i.e FRD...
- 19 Aug 2016
Demonstrating Power Measurement tool (PMT) using LPCXpreso on LPC4367 development board

bheemarao

Refer to my earlier blog on working with OM13088-LPC4367 LPCXpresso development board; i am using the same project executable of peripheral timer which blinks LED at every 1 second interrupt for demonstrating the PMT The Power measurement tool e...
- 7 Aug 2016