failing clearance checks

Question

Hi,

I tried to verify the routing, but it fails stating the clearance rules are not followed. I tried to change the clearance from 0.2mm to 0.1mm, but that didn't help.

it was even complaining about the space between stm32's pads. here are couple screenshots.

what am I doing wrong?

thansk, Alex

autodeskguest · Accepted Answer

On 28/10/2014 7:50 p.m., alex tomas wrote:

Hi,

I tried to verify the routing, but it fails stating the clearance rules
are not followed. I tried to change the clearance from 0.2mm to 0.1mm,
but that didn't help.
it was even complaining about the space between stm32's pads. here are
couple screenshots.

what am I doing wrong?

Check your net classes. The clearances specified there have to be

satisfied as well.

HTH

Warren