JUst completed PCB using eagle. All CAM files completed and zipped to ship for quote.
I need 20 boards. Files attached.
How do I begin?
JUst completed PCB using eagle. All CAM files completed and zipped to ship for quote.
I need 20 boards. Files attached.
How do I begin?
Hi Anthony,
Please see here, and contact them directly:
Cheapest PCB makers, low volume
However, you should double-check if you need to do anything with the RST pin or not, for the module you're using - it seems you've left it disconnected.
I've not used this module, so this is just a suggestion - maybe you've already confirmed.
Also, it's bad practice to have all traces at 6mil, usually at least the power traces are thickened, and all traces look autorouted and component placement could also be better.
For an initial prototype it may work enough to get by.
Hi Anthony,
Please see here, and contact them directly:
Cheapest PCB makers, low volume
However, you should double-check if you need to do anything with the RST pin or not, for the module you're using - it seems you've left it disconnected.
I've not used this module, so this is just a suggestion - maybe you've already confirmed.
Also, it's bad practice to have all traces at 6mil, usually at least the power traces are thickened, and all traces look autorouted and component placement could also be better.
For an initial prototype it may work enough to get by.
