Hi to all. I've been watching and reading the replies on this topic over the last couple of weeks since I published the link to the commercial 3D Printer company www.shapeways.com products and potential for manufacturing Pi cases. I have seen Jacob's ModmyPi site's developing case ideas and these are looking really nice. One thing I haven't read or seen in any graphics, and please correct me if I am wrong on this, but no provision seems to be gettig made for access to the onboard GPIO and JTAG headers, and CSI Connector. For those designers out there, maybe thinning the case material above these locations on the board would then allow them to be cut out by a knife or pushed out if serrated. I would prefer to do this than take to the case with a dremel!
Hi to all. I've been watching and reading the replies on this topic over the last couple of weeks since I published the link to the commercial 3D Printer company www.shapeways.com products and potential for manufacturing Pi cases. I have seen Jacob's ModmyPi site's developing case ideas and these are looking really nice. One thing I haven't read or seen in any graphics, and please correct me if I am wrong on this, but no provision seems to be gettig made for access to the onboard GPIO and JTAG headers, and CSI Connector. For those designers out there, maybe thinning the case material above these locations on the board would then allow them to be cut out by a knife or pushed out if serrated. I would prefer to do this than take to the case with a dremel!
