FPGA

Forum How to transfer data from CMOD S6 to PC continously through USB interface?

Join FPGA to participate - click to join for free!

Actions

Forum Thread Details

State Not Answered
Replies 2 replies
Subscribers 559 subscribers
Views 678 views
Users 0 members are here

Related

How to transfer data from CMOD S6 to PC continously through USB interface?

mahmood.hassan over 6 years ago

This board has micro usb connector which is connected with USB port of atmega16U2 and I know the maximum data rate is 12Mbps.

There is adept 2 software which can send and receive data using micro usb and its SDK is also available on github.

Does anyone know how to receive data in LABview?

0 clem57 over 6 years ago

On the LabVIEW side, use the VISA Write to send your data. On the Arduino side, use the Serial.readStringUntil() function to read the data. I recommend concatenating an End Of Line to the end of the string and use the Line Feed (0xA) as the "until" on the Arduino. This can be reversed by using the opposite instructions.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mahmood.hassan over 6 years ago

Its an FPGA board and atmega16U2 is used to configure the FPGA and provide USB interface between FPGA and PC.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel