FPGA

Forum Hardware Manager unconnected. Autoconnect crashes

FPGA requires membership for participation - click to join

Actions

Forum Thread Details

Replies 8 replies
Subscribers 517 subscribers
Views 330 views
Users 0 members are here

Related

Hardware Manager unconnected. Autoconnect crashes

sam_jones 1 month ago

Hi all,

i am able to run linux images on the K24 SoM board via SD card image.

However i cant access the board via JTAG. Open Hardware doesnt detect it.

I have run "install" scripts in /xicom. Other Xilinx FPGAs (e.g. Zybo) are immediately detectable.

Do i have to install any special drivers ?

Thanks

Top Replies

Parents

ahsrabrifat 1 month ago

You need a USB cable that is data-capable, not just a charging cable. Confirm that your cable is data-capable.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
sam_jones 1 month ago in reply to ahsrabrifat

Thank you for the immediate response . Could you pErhard send me a link to a data-capable USB Cable?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
kmikemoo 1 month ago in reply to sam_jones

sam_jones If your cable is communicating enough to run the install scripts, you don't need a different cable. If the cable communicates on a different system, you don't need a different cable. If you're using the really short cable that came with your (battery) power bank... try a different cable.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel
sam_jones 1 month ago in reply to kmikemoo

Thanks. My cable does all the above . Unfortunately the Zybo board that I have access to doesn’t have a USB C interface so I couldn’t verify if the cable works on other devices .
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

sam_jones 1 month ago in reply to kmikemoo

Thanks. My cable does all the above . Unfortunately the Zybo board that I have access to doesn’t have a USB C interface so I couldn’t verify if the cable works on other devices .
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data