capacitor help

need some help with a capacitor there is so much information on this cap but it does not come out and tell you the capacitance so I'm having a hard time figuring out the value to be able to replace it in the circuit I found a data sheet but it's not clear on the data sheet what the value is either so I've come here to possibly help me out with what I need to replace this capacitor I will provide photos

Attachments:

Top Comments

shabaz over 9 years ago +1

If the distance between the two pins is 22.5mm, then ILLINOIS CAPACITOR 474MKP275KB is a suitable replacement:

Parents

shabaz over 9 years ago

If the distance between the two pins is 22.5mm, then ILLINOIS CAPACITOR 474MKP275KB is a suitable replacement:
- Cancel
- Vote Up +1 Vote Down
- Sign in to reply
- More
- Cancel
Former Member over 9 years ago in reply to shabaz

This is what has me confused when i look on the data sheet i see some info that says 0.1uF and i found another one that said 0.47uF the distence is 15mm
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
shabaz over 9 years ago in reply to Former Member

If pin spacing is 15mm then F862BY474K310ALR0L is a suitable replacement (and take care not to purchase any 0,47uF cap - this one has similar ratings to yours).
The data sheet usually covers multiple values. Yours happens to be 0.47uF, but the datasheet will also cover 0.1uF, 0.22uF, etc..
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
Former Member over 9 years ago in reply to shabaz

I know im a total noob but is this cap polarized does it have to go a certain way in the circuit I just wondered because it has no Discerning Mark to say if it is or not
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel

Comment

Former Member over 9 years ago in reply to shabaz

I know im a total noob but is this cap polarized does it have to go a certain way in the circuit I just wondered because it has no Discerning Mark to say if it is or not
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel

Children

michaelwylie over 9 years ago in reply to Former Member

That does not look like a polarized cap. Any polarized cap would have the negative or positive clearly marked. Shouldn't matter what way it goes in.
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
Former Member over 9 years ago in reply to michaelwylie

i wasnt sure because the new cap has two little marks on one side and the old one has no marks on it and the pcb has no marks either i guess because it is an input Suppression cap on ac there would be not positive or negative correct?
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
michaelwylie over 9 years ago in reply to Former Member

Could be wrong but I don't see any markings in the datasheet that indicate it is polarized
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
Former Member over 9 years ago in reply to michaelwylie

Thank you very much lol ill let you know if it explodes lol have a good one
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel