Browse By Tags

  • Planes and Restrict in EagleCAD

    Hi, Using EagleCAD I have made a power circuit using a linear regulator and made little planes as recommended in the data sheet, however, when I route the board the software puts traces through these planes. I tried to use keepout but that didn't work…

  • Trace restrict in internal layers?

    I am using Eagle Standard Edition, Version 5.11.0. I am placing a bluetooth-4 radio on a 4-layer board, and need to restrict the autorouter from placing any traces under the antenna. I use rectangles in the tRestrict, bRestrict, and vRestrict layers to…

  • New restrict layer on 4-layer PCB

    I'm routing a board for RF use, there's several vias that need a specified annular ring other than defined for the other vias on the PCB, I'd like to simply draw a circle around these vias in a restrict layer, just as I've done for the top and bottom…

  • Nogo areas for inner inner layers

    Why aren't there restrict layers for inner layers? Now we have only tRestrict (41) and bRestrict (42). Please add extra restrict layers for layer 2 to 15. Thank you! Kind Regards.

  • New Restrict Layer

    Hi all, I am currently laying out a four layer PCB and need a large flood plain for heat purposes so need to use the maximum area of the board I can. but due to clearance and creepage distances with via's, drawing lots of flood plains to accomodate the…