Freedom development platform

Welcome to

KL25Z Freedom Board is our low-cost evaluation and development board featuring theCortex-M0+ based Kinetis L Series MCU exclusively available to pre order today.

Recent Discussions

Discussion

I cannot access FRDM - KL25Z via PUTTY (or similar Terminal)

1088 views

7 replies

Latest over 9 years ago
by bheemarao
Answered

Configuring the Vector Table offset when using the Kinetis Bootloader and KDS 0

672 views

2 replies

Latest over 9 years ago
by Former Member
Discussion

FRDM-K64F + KSDK SOFTWARE：How to light up a LCD screen display Chinese characters

1066 views

8 replies

Latest over 9 years ago
by Former Member
Answered

Freescale FRDM-KL25Z OPENSDA is not working 0

3786 views

24 replies

Latest over 9 years ago
by FreescaleTools_and_Software
Answered

I cannot open properly KL43Z examples in KDS 0

778 views

6 replies

Latest over 9 years ago
by FreescaleTools_and_Software

Recent Blogs

[FRDM-KL46Z + Kinetis Design Studio (KDS)] Tutorial: Displaying Time in minutes and seconds using inbuilt segment LCD

bheemarao

This tutorial brings you on getting working with 4-digit (4X8) segment LCD present in KL46Z freedom board and demonstrate Time in Minutes and Seconds.We will use the Freescale’s new Kinetis Design Studio Based on free, open-source software including …
- 11 Aug 2014
[FRDM-K64F + Kinetis Design Studio (KDS)] Tutorial: Toggling an RGB LED using interrupts

bheemarao

Here is a tutorial for toggling 3-led’s by pressing one switch using interrupt logic implemented using FRDM-K64F on Kinetis Design Studio. Before i start my project make sure to have below requisites: KDS software installed in your PC You c...
- 3 Aug 2014
[FRDM-K64F - KDS - OpenSDAv2] Tutorial: Set-up the debug interface

bheemarao

In this demo, I am using OpenSDA / OpenSDA V2 firmware provided from Segger, this firmware supports all ARM based Freescale boards which comes with on-board OpenSDA and Implements SWD debug protocol and virtual COM port functionality. By...
- 30 Jul 2014