Thanks to Pekka Jäppinen for comments on the text. BackgroundMy initial inspiration for getting into home automation was the fact that my dad started to build a house to “the middle of nowhere”. He currently works about 800 kilometers from the h...
This is my summary for the Forget Me Not challenge. When this Challenge was first presented, I thought about what I could offer as a solution. These are all very noble reasons to utilize the power ...
In my last post, I showed how we can connect individual room controllers to the main hub( raspberry pi ) using a home network and also how Paho MQTT library comes handy for the communication between them. Basically a room controller takes care of all...
Pas Home - Index For several weeks I try to find and implement a functional version of my curtain opener. This is the progress up the final version. Step 1 Remember the drille Pas Home / Curtain open close prototype 1First test a made ...
Thanks to Element 14 and the sponsors for holding the Forget-Me-Not Design Challenge. Also a big thanks to fellow Element 14 members for teaching me new ways of using OpenHAB. I learned a lot of neat tricks, and I read lots of creative us...
Pas Home - Index Here are the most detailed instruction to manufacture of a very simple braket for the temperature sensor Step 1Cute 4.5mm acrylic clear board with a Jigsaw to made a rectangle of 3cm x 13cm Step 2Sand the side of...
Acknowledgement
Prelude
Introduction
Project Goals and problem statement
Goals:
System Block Diagram
Modules - Functionality & Applications & Advantages
Module I. The waiting platform- Forget not anything outside the fridge.
Mo...
Introduction
The Sensors
MET MQTT Station
The software
Public Display of Data
IntroductionThe requirement for this module was to have a weather station that would transmit weather data over the internet to OpenHAB. Why the internet? because...
Good morning, and welcome to the final week of the Forget Me Not Challenge -Minion Dave is surprised at how quickly time has flownAs the cliche goes, all good things must come to an end, and the Forget Me Not Challenge has been a very good thing inde...
This is an update to the IQU project entered in the Forget Me Not Design challenge showing a STM320U sensor mounted on a window frame to detect when the window is open.I mounted an STM320U on one of the window frames in my house that is prone to lett...
"If something works for some one, it doesn't mean that it will work for you" -- this is the hard lesson I learned in past weeks. I was caught in between some personal matters for last two weeks and didn't gave much time for the challenge. I'm so asha...
ForewordBeware, a lot of images, problems, failures (with a mix of success) to follow! Also, written quite hastily, so the text itself might be confusing The events following occur during 2 days.For some reason, my Linux decided that it doesn’t want ...
Table of Contents In My Previous Post , I have shared build of my LPG and Smoke sensor..Today I am sharing my PIR motion sensor build based on STM330.. This is my last sensor.. I have shared Circuit diagram of all my sensors in this post&...
Poll DancingFigure 1. If you look carefully you'll see the new addition at the bottom left hand corner and if you look very very carefully an attached DS2401!(and 3 Oscilloscope leads - two for I2C bus observation and the other for 1-Wire bus obs...
