You asked for it, and Clem delivers! After he built the Phone to Printer Port adapter, a lot of viewers were asking if it was possible to add Wi-Fi to this old dot-matrix printer. Clem takes on the challenge, and walks you through the troubleshooting and solution finding to add Wi-Fi to any old printer!
Supplemental Content:
Bill of Material:
| Product Name | Manufacturer | Quantity | Buy Kit |
|---|---|---|---|
| "SAMTEC USB Connector | SAMTEC | 1 | Buy Now |
| "MULTICOMP USB Cable | MULTICOMP | 1 | Buy Now |
| "MULTICOMP PRO Through Hole Resistor | MULTICOMP PRO | 3 | Buy Now |
| "MULTICOMP PRO D Sub Connector | MULTICOMP PRO | 1 | Buy Now |
Additional Parts:
| Dotmatrix / needle printer |
| SubD25 to centronix cable |
| ESP32-S2-wroom-module |
| Logic level converter boards. |
